Drubber- Tyre And Dashboard Polish for Car | Non Oily | Long Lasting | Pleasant Smelling

KKE Drubber Tyre & Dashboard Polish is the one bottle that takes care of your car's three most-visible surfaces — tyre sidewalls on the outside, and the dashboard and bumpers on the inside and out. Non-oily, long-lasting, and genuinely pleasant to use, it's the polish you'll actually reach for every week.

Most dashboard polishes leave a tacky, oily layer — fingers stick, dust sticks, and the surface slowly turns into a grime magnet. Drubber is formulated to be completely non-oily. Its water-based, natural wax blend dries to a clean, satin-smooth finish that looks rich and feels clean to the touch — not coated. No sunlight glare, no fingerprint smudges, no slippery film.

Ordinary tyre dressings sit on the surface and wash off with the first puddle. Drubber's advanced silicone bonding technology grips the rubber, while a premium Carnauba and Beeswax overcoat seals the finish against water, UV rays, and road grime. The result is a deep, professional black that holds for up to 7 days of daily driving.

Drubber's built-in anti-static agents neutralise the static charge that pulls fine dust onto dashboard surfaces. The ultra-smooth surface film it leaves behind gives dust particles almost nothing to cling to — tested in 40°C+ heat, off-road dust, and the dry climates of India and the GCC region.

• Tyres — deep black, long-lasting, professional wet look with rain resistance.
• Dashboard — rich satin appearance, anti-dust, non-oily, safe for enclosed cabins.
• Bumpers & plastic trim — restores faded plastic to its original colour and finish.

It also works on door trims, rubber seals, plastic fenders, and vinyl surfaces — anywhere you need a clean, finished look.

1. Clean the tyres thoroughly to remove dirt, grime, and debris (KKE APC or warm soapy water works well).
2. Once clean and dry, apply a small amount of Drubber to a cloth or sponge.
3. Rub onto the tyre sidewall in a circular motion, covering the entire surface.
4. Allow the polish to sit for a few minutes to bond with the rubber.
5. For a matte finish: wipe off any excess with a microfiber towel.
6. For a glossy finish: apply an additional light layer and leave to set.

1. Wipe the surface clean of dust and dirt first.
2. Spray Drubber lightly onto a clean microfiber cloth.
3. Wipe in long, even strokes across the surface.
4. Buff lightly for a slightly less reflective finish, or leave for maximum shine.
5. Tip: Always apply to cool surfaces in the shade — hot dashboards can cause uneven setting.

Drubber's high-melting-point natural wax system stays hard even when bumper surfaces reach 60°C+ in direct sun — it won't melt, drip, or turn tacky in peak summer conditions. The water-based formula contains over 90% biodegradable, naturally derived ingredients with no petroleum solvents, making it a responsible everyday choice for both home detailers and professional workshops.